Mikron Stinger 2 Manual de Instruções Página 1

1 STINGER 2 User’s Operating Manual ______________________________________________________________________ Made i

10 the symbol „_―. If there is a difference in both levels balance of the device should be performed through „POWER / CLEAR“. In th

11 is done as follows: the „STORE“ button is pressed and held and to the searching coil a definite type of nonferrous metal is approa

12 In the „auto discr“ / „reject“ mode the device memorizes only the purity coefficient ID1 of a metal, and in the “AUTO DISCR“ / „

13 items or under active stones and highly mineralized soils. In this case, if, for example, an object (stone, ceramics or some iron) has been mem

14 be performed in this mode is to press „ON – OFF / CLEAR“ for short, as the searching coil has to be close to the ground surface, at the distance a

15 The accumulators' status is shown on the first row on the right as per cents of the capacity (0%-100%). When the capacity decreases below 0

16 them is damaged the connection between them is destroyed and practically the device will be left without power supply. 6.2. The working depth is

17 service-station (office) of the company manufacturer or the local distributor for change of the storage batteries. The Manufacturer (trad

18 any moisture or water from entering the control housing and never allow the cable connector to become submerged in water.  If working in or near

2 In order to use the device for a maximum long time and without problems, as well as to be able to use all of its options, please read carefully the

3 position of the coil to be parallel to the ground surface. Don't over-tighten the plastic bolt and nut to not damage the threading of the bolt

4 "DISCR", you have to push the button "VCO / DISCR", at which the device is switched into discrimination mode and the displ

5 degree of mineralization of soil. For example, in order to understand how strong is the signal from the soil on a definite location, one ca

6 sound. This is done with change in the parameter "Thresh. For this purpose, through the buttons "◄ and ►" desired value can be selec

7 shorten the sweeps until you just barely get a response at one spot. The target will be directly below the coil center at this response time – fig.

8 After each change of some of these 3 parameters, the device automatically restarts in order the respective settings to be loaded according to the

9 Upon localization of foil, aluminium and unstained iron, ID1 and ID2 have their negative values, and both of them have great pos